How to Replace a Vinyl Floor with Ceramic Tile

Watch the full episode: http://ift.tt/2trcyIF Ask This Old House general contractor Tom Silva helps a homeowner replace the peeling, vinyl floor in his bathroom with a ceramic tile floor Click here to SUBSCRIBE to the official This Old House YouTube channel: http://www.youtube.com/subscription_center?add_user=thisoldhouse Time: 2 days Cost: $200 Skill Level: Moderate Tools List for Replacing a Vinyl Floor with Ceramic Tile: Open ended adjustable wrench Utility knife Pry bar Hammer Putty knife Jigsaw Carbide tip knife Notched trowel Drill driver Wet saw Rubber float Sponge Bucket Shopping List: Tiles Cement board Thinset mortar 1 ¼” cement screws Mesh tape Grout Steps: 1. Before getting started, all the appliances need to be removed. Disconnect and remove any sinks, vanities (http://ift.tt/2tAT9Fw ), and toilets (http://ift.tt/2p05GNG ) in the bathroom. Loosen the flange and hold it up with spacers if possible. 2. Next, remove any baseboard trim with the pry bar. 3. Once the floor is clear, peel off the vinyl tiles with a putty knife. With the floor up, now is good opportunity to ensure the subfloor is properly secured. 4. Add cement board to the subfloor to act as a base for the tiles. Cut it to size by scoring it with the carbide tip knife and snapping it, similar to drywall. 5. Apply the thinset to the floor using the notched trowel. 6. Secure the cement board to the floor using the cement screws about 8” apart. Make sure the cement board goes underneath the toilet flange. Cover the seams between the cement board with mesh tape. 7. Dry fit the tiles to see how they will fit in the room. Measure and mark tiles that need to be cut. 8. Cut the tiles using a wet saw. 9. Apply thinset to the cement board using the notched trowel and lay the tiles on the floor. Nippers can be used to cut around the flange. Allow the thinset to cure for 24 hours. 10. Grout the tile after 24 hours. 11. Reinstall the vanity and toilet. Resources: Tom chose a mosaic 12x12 inch tile with mesh backing from Daltile (https://www.daltile.com ). For the subfloor, he used ¼ inch Wonderboard lite cement board underlayment. For mortar, Tom used versabond thinset. To trim the bottom of the casings, Tom used an osculating saw available at Home Depot (http://ift.tt/2Dgh7oJ ). All of these materials can be purchased at a home center. Follow This Old House and Ask This Old House: Facebook: http://ift.tt/1psm4fC Twitter: https://twitter.com/thisoldhouse https://twitter.com/asktoh Pinterest: http://ift.tt/1psm4fE G+: http://ift.tt/1CtsNjJ Instagram: http://ift.tt/1psm1QZ Tumblr: http://ift.tt/1CtsLbH